* fix M48 for delta printers
fix M48 for delta printers. home printer if not already homed.
* remove ENABLED(DELTA)
remove ENABLED(DELTA) as it is not needed.
* Update M48.cpp
* abl needs queue.h
without queue.h abl will not compile since there is a script that runs at the end of it and we need to queue it up.
* Update Conditionals_post.h
* Add a cast to round() to convert to a unsigned int
Add's a cast to round() so that it will compile properly. round() returns a float which must be cast to a integer for the following % operation. Use a unsigned int as a negative index to an array is wrong. Should never be more than 255 points allowing us to use a 8 bit cast.
* Update G33.cpp
* [2.0.x] Fix NO_MOTION_BEFORE_HOMING unwanted behaviour
NO_MOTION_BEFORE_HOMING should prevent XYZ movements only when homing is not done.
E axes should be allowed
* Update G0_G1.cpp
* Update G0_G1.cpp
* Merging early because of build failures. See #8105
* Make LPC1768 pinmapping not specific to Re-ARM
* Add HAL_PIN_TYPE and LPC1768 pin features
* M43 Updates
* Move pin map into pinsDebug_LPC1768.h
* Incorporate comments and M226
* Fix persistent store compilation issues
* Update pin features
* Update MKS SBASE pins
* Use native LPC1768 pin numbers in M42, M43, and M226
* Enable hardware serial ports on LPC1768
* Fix compilation errors with other HALs
* FIx order of includes in LPC1768 HAL main.cpp
* Add support for RX_BUFFER_SIZE and TX_BUFFER_SIZE options in Configuration_adv.h
Same as #7728 but for 2.0.x,
Lot of cleanup and remove references in whole code to other "LED files" than leds.h. Now will be much easier to add next drivers/libraries. e.g. FastLED. But bad news, currently FastLED is suporting only RGB devices (no RGBW)
Scott Lahteine
Thomas Moore
Colten Edwards
Luc Van Daele
GMagician
Thomas Moore
Roxy-3D
gallynero
Slawomir Ciunczyk
Christopher Pepper
Phr3d13