Browse Source

Config file Z_PROBE_AND_ENDSTOP description clean up.

pull/1/head
Chris Roadfeldt 10 years ago
parent
commit
fe4549cd83
  1. 9
      Marlin/Configuration.h

9
Marlin/Configuration.h

@ -491,14 +491,13 @@ const bool Z_PROBE_ENDSTOP_INVERTING = false; // set to true to invert the logic
#endif
// Seaparte concurrent Z Probe and Z min endstop support
// Support for concurrent and seperate Z Probe and Z min endstop use.
// Added by Chris Roadfeldt 3-28-2015
// If you have a Z Probe in addition to a Z min endstop, uncomment the #define Z_PROBE_AND_ENDSTOP line below and configure Z Probe settings.
// Only use this if you have both a Z PROBE and Z Min ENDSTOP.
// Note: It's expected that your Z Probe triggers in the direction towards your bed.
// If you would like to use both a Z Probe and a Z min endstop at the same time, uncomment #define Z_PROBE_AND_ENDSTOP below
// You will want to disable Z_SAFE_HOMING above as you will still use the Z min endstop for homing.
// In order to use this, you must have a Z_PROBE_PIN defined in the pins.h file for your control board.
// RAMPS 1.3/1.4 boards may be able to use the 5V, Ground and the D32 pin in the Aux 4 section of the RAMPS board for the signal.
// The D32 pin in Aux 4 on RAMPS maps to the Arduino D32 pin. The Z_PROBE_PIN is setting the pin to use on the Arduino. Since the D32 pin on the RAMPS maps to D32 on Arduino, this works.
// The D32 pin in Aux 4 on RAMPS maps to the Arduino D32 pin. Z_PROBE_PIN is setting the pin to use on the Arduino. Since the D32 pin on the RAMPS maps to D32 on Arduino, this works.
// D32 is currently selected in the RAMPS 1.3/1.4 pin file. Update the pins.h file for your control board to make use of this. Not doing so nullifies Z_PROBE_AND_ENDSTOP
// WARNING: Setting the wrong pin may have unexpected and disastrous outcomes. Use with caution and do your homework.
// #define Z_PROBE_AND_ENDSTOP

Loading…
Cancel
Save