Browse Source

Tweak M105 layout

pull/1/head
Scott Lahteine 5 years ago
parent
commit
faacfe13c2
  1. 15
      Marlin/src/gcode/temperature/M105.cpp

15
Marlin/src/gcode/temperature/M105.cpp

@ -31,18 +31,21 @@ void GcodeSuite::M105() {
const int8_t target_extruder = get_target_extruder_from_command(); const int8_t target_extruder = get_target_extruder_from_command();
if (target_extruder < 0) return; if (target_extruder < 0) return;
#if HAS_TEMP_SENSOR
SERIAL_ECHOPGM(MSG_OK); SERIAL_ECHOPGM(MSG_OK);
#if HAS_TEMP_SENSOR
thermalManager.print_heater_states(target_extruder thermalManager.print_heater_states(target_extruder
#if ENABLED(TEMP_SENSOR_1_AS_REDUNDANT) #if ENABLED(TEMP_SENSOR_1_AS_REDUNDANT)
, parser.boolval('R') , parser.boolval('R')
#endif #endif
); );
#else // !HAS_TEMP_SENSOR
// Hosts such as printrun send M105 to check if firmware is responding.
SERIAL_ECHOPGM(MSG_OK);
SERIAL_ECHOPGM(" T:0");
#endif
SERIAL_EOL(); SERIAL_EOL();
#else
SERIAL_ECHOLNPGM(" T:0"); // Some hosts send M105 to test the serial connection
#endif
} }

Loading…
Cancel
Save