Remove duplicated Z_PROBE_OFFSET_RANGE_MIN, Z_PROBE_OFFSET_RANGE_MAX

Marlin/example_configurations/Hephestos_2/Configuration.h

@@ -512,8 +512,8 @@ const bool Z_MIN_PROBE_ENDSTOP_INVERTING = false; // set to true to invert the l
 //
 // For M851 give a range for adjusting the Z probe offset
 //
-#define Z_PROBE_OFFSET_RANGE_MIN -20
-#define Z_PROBE_OFFSET_RANGE_MAX 20
+#define Z_PROBE_OFFSET_RANGE_MIN -5
+#define Z_PROBE_OFFSET_RANGE_MAX  0
 
 // For Inverting Stepper Enable Pins (Active Low) use 0, Non Inverting (Active High) use 1
 // :{0:'Low',1:'High'}
@@ -733,11 +733,6 @@ const bool Z_MIN_PROBE_ENDSTOP_INVERTING = false; // set to true to invert the l
 //============================= Additional Features ===========================
 //=============================================================================
 
-// @section probes
-
-#define Z_PROBE_OFFSET_RANGE_MIN -5
-#define Z_PROBE_OFFSET_RANGE_MAX  0
-
 // @section extras
 
 //

Marlin/example_configurations/delta/kossel_pro/Configuration.h

@@ -588,8 +588,8 @@ const bool Z_MIN_PROBE_ENDSTOP_INVERTING = false; // set to true to invert the l
 //
 // For M851 give a range for adjusting the Z probe offset
 //
-#define Z_PROBE_OFFSET_RANGE_MIN -20
-#define Z_PROBE_OFFSET_RANGE_MAX 20
+#define Z_PROBE_OFFSET_RANGE_MIN -15
+#define Z_PROBE_OFFSET_RANGE_MAX   5
 
 // For Inverting Stepper Enable Pins (Active Low) use 0, Non Inverting (Active High) use 1
 // :{0:'Low',1:'High'}
@@ -821,11 +821,6 @@ const bool Z_MIN_PROBE_ENDSTOP_INVERTING = false; // set to true to invert the l
 //============================= Additional Features ===========================
 //=============================================================================
 
-// @section probes
-
-#define Z_PROBE_OFFSET_RANGE_MIN -15
-#define Z_PROBE_OFFSET_RANGE_MAX   5
-
 // @section extras
 
 //