Browse Source

📝 Tweak G26 Q description

FB4S_WIFI
Scott Lahteine 4 years ago
parent
commit
f33ec4aacf
  1. 4
      Marlin/src/gcode/bedlevel/G26.cpp

4
Marlin/src/gcode/bedlevel/G26.cpp

@ -71,8 +71,8 @@
* pliers while holding the LCD Click wheel in a depressed state. If you do not have * pliers while holding the LCD Click wheel in a depressed state. If you do not have
* an LCD, you must specify a value if you use P. * an LCD, you must specify a value if you use P.
* *
* Q # Multiplier Retraction Multiplier. Normally not needed. Retraction defaults to 1.0mm and * Q # Multiplier Retraction Multiplier. (Normally not needed.) During G26 retraction will use the length
* un-retraction is at 1.2mm These numbers will be scaled by the specified amount * specified by this parameter (1mm by default). Recover will be 1.2x the retract distance.
* *
* R # Repeat Prints the number of patterns given as a parameter, starting at the current location. * R # Repeat Prints the number of patterns given as a parameter, starting at the current location.
* If a parameter isn't given, every point will be printed unless G26 is interrupted. * If a parameter isn't given, every point will be printed unless G26 is interrupted.

Loading…
Cancel
Save