Browse Source

Don't check Z_MAX on raise when the probe pwns the pin

pull/1/head
Scott Lahteine 8 years ago
parent
commit
ed7d2694fc
  1. 12
      Marlin/endstops.cpp

12
Marlin/endstops.cpp

@ -315,7 +315,7 @@ void Endstops::update() {
#else
if (stepper.motor_direction(Z_AXIS))
#endif
{ // z -direction
{ // Z -direction. Gantry down, bed up.
#if HAS_Z_MIN
#if ENABLED(Z_DUAL_ENDSTOPS)
@ -341,6 +341,7 @@ void Endstops::update() {
#endif // HAS_Z_MIN
// When closing the gap check the enabled probe
#if ENABLED(Z_MIN_PROBE_ENDSTOP)
if (z_probe_enabled) {
UPDATE_ENDSTOP(Z, MIN_PROBE);
@ -348,9 +349,10 @@ void Endstops::update() {
}
#endif
}
else { // z +direction
else { // Z +direction. Gantry up, bed down.
#if HAS_Z_MAX
// Check both Z dual endstops
#if ENABLED(Z_DUAL_ENDSTOPS)
UPDATE_ENDSTOP_BIT(Z, MAX);
@ -362,11 +364,13 @@ void Endstops::update() {
test_dual_z_endstops(Z_MAX, Z2_MAX);
#else // !Z_DUAL_ENDSTOPS
// If this pin is not hijacked for the bed probe
// then it belongs to the Z endstop
#elif DISABLED(Z_MIN_PROBE_ENDSTOP) || Z_MAX_PIN != Z_MIN_PROBE_PIN
UPDATE_ENDSTOP(Z, MAX);
#endif // !Z_DUAL_ENDSTOPS
#endif // !Z_MIN_PROBE_PIN...
#endif // Z_MAX_PIN
}
#if ENABLED(COREXZ)

Loading…
Cancel
Save