|
|
@ -471,6 +471,12 @@ const bool Z_MIN_PROBE_ENDSTOP_INVERTING = false; // set to true to invert the l |
|
|
|
// If you're using the Z MIN endstop connector for your Z probe, this has no effect.
|
|
|
|
//#define DISABLE_Z_MIN_PROBE_ENDSTOP
|
|
|
|
|
|
|
|
// Probe Raise options provide clearance for the probe to deploy and stow.
|
|
|
|
// For G28 these apply when the probe deploys and stows.
|
|
|
|
// For G29 these apply before and after the full procedure.
|
|
|
|
#define Z_RAISE_BEFORE_PROBING 100 // Raise before probe deploy (e.g., the first probe).
|
|
|
|
#define Z_RAISE_AFTER_PROBING 15 // Raise before probe stow (e.g., the last probe).
|
|
|
|
|
|
|
|
// For Inverting Stepper Enable Pins (Active Low) use 0, Non Inverting (Active High) use 1
|
|
|
|
// :{0:'Low',1:'High'}
|
|
|
|
#define X_ENABLE_ON 0 |
|
|
@ -647,9 +653,7 @@ const bool Z_MIN_PROBE_ENDSTOP_INVERTING = false; // set to true to invert the l |
|
|
|
|
|
|
|
#define XY_TRAVEL_SPEED 8000 // X and Y axis travel speed between probes, in mm/min.
|
|
|
|
|
|
|
|
#define Z_RAISE_BEFORE_PROBING 100 // How much the Z axis will be raised before traveling to the first probing point.
|
|
|
|
#define Z_RAISE_BETWEEN_PROBINGS 5 // How much the Z axis will be raised when traveling from between next probing points.
|
|
|
|
#define Z_RAISE_AFTER_PROBING 15 // How much the Z axis will be raised after the last probing point.
|
|
|
|
|
|
|
|
//#define Z_PROBE_END_SCRIPT "G1 Z10 F12000\nG1 X15 Y330\nG1 Z0.5\nG1 Z10" // These commands will be executed in the end of G29 routine.
|
|
|
|
// Useful to retract a deployable Z probe.
|
|
|
|