|
|
|
@ -192,7 +192,7 @@ |
|
|
|
* M407 - Display measured filament diameter in millimeters. (Requires FILAMENT_WIDTH_SENSOR) |
|
|
|
* M410 - Quickstop. Abort all planned moves. |
|
|
|
* M420 - Enable/Disable Leveling (with current values) S1=enable S0=disable (Requires MESH_BED_LEVELING or ABL) |
|
|
|
* M421 - Set a single Z coordinate in the Mesh Leveling grid. X<units> Y<units> Z<units> (Requires MESH_BED_LEVELING or AUTO_BED_LEVELING_UBL) |
|
|
|
* M421 - Set a single Z coordinate in the Mesh Leveling grid. X<units> Y<units> Z<units> (Requires MESH_BED_LEVELING, AUTO_BED_LEVELING_BILINEAR, or AUTO_BED_LEVELING_UBL) |
|
|
|
* M428 - Set the home_offset based on the current_position. Nearest edge applies. (Disabled by NO_WORKSPACE_OFFSETS or DELTA) |
|
|
|
* M500 - Store parameters in EEPROM. (Requires EEPROM_SETTINGS) |
|
|
|
* M501 - Restore parameters from EEPROM. (Requires EEPROM_SETTINGS) |
|
|
|
|
Scott Lahteine
6 years ago