Browse Source

Add a filament runout note (#19973)

Co-authored-by: Scott Lahteine <thinkyhead@users.noreply.github.com>
vanilla_fb_2.0.x
Victor Oliveira 4 years ago
committed by Scott Lahteine
parent
commit
b79e2d1e8d
  1. 6
      Marlin/Configuration.h

6
Marlin/Configuration.h

@ -1170,6 +1170,12 @@
* Filament Runout Sensors * Filament Runout Sensors
* Mechanical or opto endstops are used to check for the presence of filament. * Mechanical or opto endstops are used to check for the presence of filament.
* *
* IMPORTANT: Runout will only trigger if Marlin is aware that a print job is running.
* Marlin knows a print job is running when:
* 1. Running a print job from media started with M24.
* 2. The Print Job Timer has been started with M75.
* 3. The heaters were turned on and PRINTJOB_TIMER_AUTOSTART is enabled.
*
* RAMPS-based boards use SERVO3_PIN for the first runout sensor. * RAMPS-based boards use SERVO3_PIN for the first runout sensor.
* For other boards you may need to define FIL_RUNOUT_PIN, FIL_RUNOUT2_PIN, etc. * For other boards you may need to define FIL_RUNOUT_PIN, FIL_RUNOUT2_PIN, etc.
*/ */

Loading…
Cancel
Save