Browse Source

Clean up some MMU comments

vanilla_fb_2.0.x
Scott Lahteine 4 years ago
parent
commit
abc5c93986
  1. 16
      Marlin/Configuration_adv.h

16
Marlin/Configuration_adv.h

@ -3429,12 +3429,15 @@
/**
* MMU Extruder Sensor
* Add support for Prusa IR Sensor (or other) to detect that filament reach the extruder to make loading filament more reliable
* If your extruder is equipped with a filament sensor located less than 38mm from the gears you can use this feature
* During loading to the extruder, the sensor will stop the loading command when he's triggered and make a last move to load filament to the gears
* If no filament is detected, MMU2 will make more loading attemps, if finally no filament is detected, the printer will enter in runout state
*
* Support for a Prusa (or other) IR Sensor to detect filament near the extruder
* and make loading more reliable. Suitable for an extruder equipped with a filament
* sensor less than 38mm from the gears.
*
* During loading the extruder will stop when the sensor is triggered, then do a last
* move up to the gears. If no filament is detected, the MMU2 can make some more attempts.
* If all attempts fail, a filament runout will be triggered.
*/
//#define MMU_EXTRUDER_SENSOR
#if ENABLED(MMU_EXTRUDER_SENSOR)
#define MMU_LOADING_ATTEMPTS_NR 5 //max. number of attempts to load filament if first load fail
@ -3442,10 +3445,9 @@
/**
* Using a sensor like the MMU2S
* This mode only work if you have a MK3S extruder with sensor sensing the extruder idler mmu2s
* This mode requires a MK3S extruder with a sensor at the extruder idler, like the MMU2S.
* See https://help.prusa3d.com/en/guide/3b-mk3s-mk2-5s-extruder-upgrade_41560, step 11
*/
//#define PRUSA_MMU2_S_MODE
#if ENABLED(PRUSA_MMU2_S_MODE)
#define MMU2_C0_RETRY 5 // Number of retries (total time = timeout*retries)

Loading…
Cancel
Save