Browse Source

Merge pull request #893 from MyMakibox/patch-1

Update Configuration_adv.h
pull/1/head
nothinman 11 years ago
parent
commit
a33f099547
  1. 2
      Marlin/Configuration_adv.h

2
Marlin/Configuration_adv.h

@ -30,7 +30,7 @@
//automatic temperature: The hot end target temperature is calculated by all the buffered lines of gcode. //automatic temperature: The hot end target temperature is calculated by all the buffered lines of gcode.
//The maximum buffered steps/sec of the extruder motor are called "se". //The maximum buffered steps/sec of the extruder motor are called "se".
//You enter the autotemp mode by a M109 S<mintemp> T<maxtemp> F<factor> //You enter the autotemp mode by a M109 S<mintemp> B<maxtemp> F<factor>
// the target temperature is set to mintemp+factor*se[steps/sec] and limited by mintemp and maxtemp // the target temperature is set to mintemp+factor*se[steps/sec] and limited by mintemp and maxtemp
// you exit the value by any M109 without F* // you exit the value by any M109 without F*
// Also, if the temperature is set to a value <mintemp, it is not changed by autotemp. // Also, if the temperature is set to a value <mintemp, it is not changed by autotemp.

Loading…
Cancel
Save