Browse Source

Added a workaround. Ramps SD card does not have sdcarddetect. My temporary solution is to add a momentary swtich

that pulls down the SDCARDDETECT pin and mimicking the pull and reinsert ofa a SD card
pull/1/head
Blair Thompson 13 years ago
parent
commit
a05a261b72
  1. 7
      Marlin/Configuration.h
  2. 8
      Marlin/pins.h
  3. 7
      Marlin/ultralcd.h

7
Marlin/Configuration.h

@ -179,6 +179,13 @@ const bool Z_ENDSTOPS_INVERTING = false; // set to true to invert the logic of t
//#define ULTRA_LCD //general lcd support, also 16x2 //#define ULTRA_LCD //general lcd support, also 16x2
#define SDSUPPORT // Enable SD Card Support in Hardware Console #define SDSUPPORT // Enable SD Card Support in Hardware Console
// Invert the SD card Detect Pin.
// If you are using a RAMPS board or cheap E-bay purchased boards that do not detect when an SD card is inserted
// You can get round this by connecting a push button or single throw switch to the pin defined as SDCARDCARDDETECT
// in the pins.h file. When using a push button pulling the pin to ground this will need inverted. This setting should
// be commented out otherwise
#define SDCARDDETECTINVERTED
#define ULTIPANEL #define ULTIPANEL
#ifdef ULTIPANEL #ifdef ULTIPANEL
#define NEWPANEL //enable this if you have a click-encoder panel #define NEWPANEL //enable this if you have a click-encoder panel

8
Marlin/pins.h

@ -281,8 +281,8 @@
#ifdef ULTRA_LCD #ifdef ULTRA_LCD
#ifdef NEWPANEL #ifdef NEWPANEL
//arduino pin witch triggers an piezzo beeper //arduino pin which triggers an piezzo beeper
#define BEEPER -1 // No Beeper added #define BEEPER 33 // Beeper on AUX-4
#define LCD_PINS_RS 16 #define LCD_PINS_RS 16
#define LCD_PINS_ENABLE 17 #define LCD_PINS_ENABLE 17
@ -300,7 +300,7 @@
#define BLEN_B 1 #define BLEN_B 1
#define BLEN_A 0 #define BLEN_A 0
#define SDCARDDETECT -1 // Ramps does not use this port #define SDCARDDETECT 31 // Ramps does not use this port
//encoder rotation values //encoder rotation values
#define encrot0 0 #define encrot0 0
@ -310,7 +310,7 @@
#else //old style panel with shift register #else //old style panel with shift register
//arduino pin witch triggers an piezzo beeper //arduino pin witch triggers an piezzo beeper
#define BEEPER -1 No Beeper added #define BEEPER 33 No Beeper added
//buttons are attached to a shift register //buttons are attached to a shift register
// Not wired this yet // Not wired this yet

7
Marlin/ultralcd.h

@ -27,8 +27,15 @@
#define CLICKED (buttons&EN_C) #define CLICKED (buttons&EN_C)
#define BLOCK {blocking=millis()+blocktime;} #define BLOCK {blocking=millis()+blocktime;}
#ifdef SDCARDDETECTINVERTED
#define CARDINSERTED (READ(SDCARDDETECT)!=0)
#else
#define CARDINSERTED (READ(SDCARDDETECT)==0) #define CARDINSERTED (READ(SDCARDDETECT)==0)
#endif //SDCARDTETECTINVERTED
#else #else
//atomatic, do not change //atomatic, do not change

Loading…
Cancel
Save