🎨 Tweak pins, comment formatting

Marlin/src/module/settings.cpp

@@ -2397,13 +2397,15 @@ void MarlinSettings::postprocess() {
       UNUSED(s);
     }
 
-    const uint16_t MarlinSettings::meshes_end = persistentStore.capacity() - 129; // 128 (+1 because of the change to capacity rather than last valid address)
+    // 128 (+1 because of the change to capacity rather than last valid address)
     // is a placeholder for the size of the MAT; the MAT will always
     // live at the very end of the eeprom
+    const uint16_t MarlinSettings::meshes_end = persistentStore.capacity() - 129;
 
     uint16_t MarlinSettings::meshes_start_index() {
-      return (datasize() + EEPROM_OFFSET + 32) & 0xFFF8;  // Pad the end of configuration data so it can float up
+      // Pad the end of configuration data so it can float up
       // or down a little bit without disrupting the mesh data
+      return (datasize() + EEPROM_OFFSET + 32) & 0xFFF8;
     }
 
     #define MESH_STORE_SIZE sizeof(TERN(OPTIMIZED_MESH_STORAGE, mesh_store_t, ubl.z_values))

Marlin/src/pins/stm32f1/pins_CREALITY_V4.h

@@ -154,11 +154,9 @@
 #define SDIO_SUPPORT
 #define NO_SD_HOST_DRIVE                          // This board's SD is only seen by the printer
 
-#if ENABLED(CR10_STOCKDISPLAY) && NONE(RET6_12864_LCD, VET6_12864_LCD)
-  #error "Define RET6_12864_LCD or VET6_12864_LCD to select pins for CR10_STOCKDISPLAY with the Creality V4 controller."
-#endif
+#if ENABLED(CR10_STOCKDISPLAY)
 
-#if ENABLED(RET6_12864_LCD)
+  #if ENABLED(RET6_12864_LCD)
 
     // RET6 12864 LCD
     #define LCD_PINS_RS                     PB12
@@ -173,7 +171,7 @@
       #define BEEPER_PIN                    PC6
     #endif
 
-#elif ENABLED(VET6_12864_LCD)
+  #elif ENABLED(VET6_12864_LCD)
 
     // VET6 12864 LCD
     #define LCD_PINS_RS                     PA4
@@ -184,6 +182,10 @@
     #define BTN_EN1                         PB10
     #define BTN_EN2                         PA6
 
+  #else
+    #error "Define RET6_12864_LCD or VET6_12864_LCD to select pins for CR10_STOCKDISPLAY with the Creality V4 controller."
+  #endif
+
 #elif EITHER(DWIN_CREALITY_LCD, IS_DWIN_MARLINUI)
 
   // RET6 DWIN ENCODER LCD