Small fixes after merge

Marlin/Configuration.h

@@ -183,13 +183,6 @@ const bool Z_ENDSTOPS_INVERTING = false; // set to true to invert the logic of t
 #define SDSUPPORT // Enable SD Card Support in Hardware Console
 
 //#define ULTIPANEL
-// If you are using a RAMPS board or cheap E-bay purchased boards that do not detect when an SD card is inserted
-// You can get round this by connecting a push button or single throw switch to the pin defined as SDCARDCARDDETECT 
-// in the pins.h file.  When using a push button pulling the pin to ground this will need inverted.  This setting should
-// be commented out otherwise
-#define SDCARDDETECTINVERTED 
-
-#define ULTIPANEL
 #ifdef ULTIPANEL
   #define NEWPANEL  //enable this if you have a click-encoder panel
   #define SDSUPPORT

Marlin/Configuration_adv.h

@@ -148,6 +148,12 @@
 
 const int dropsegments=5; //everything with less than this number of steps will be ignored as move and joined with the next movement
 
+// If you are using a RAMPS board or cheap E-bay purchased boards that do not detect when an SD card is inserted
+// You can get round this by connecting a push button or single throw switch to the pin defined as SDCARDCARDDETECT 
+// in the pins.h file.  When using a push button pulling the pin to ground this will need inverted.  This setting should
+// be commented out otherwise
+//#define SDCARDDETECTINVERTED 
+
 //===========================================================================
 //=============================Buffers           ============================
 //===========================================================================

Marlin/ultralcd.h

@@ -28,16 +28,11 @@
     #define CLICKED (buttons&EN_C)
     #define BLOCK {blocking=millis()+blocktime;}
     #if (SDCARDDETECT > -1)
-    {
-
       #ifdef SDCARDDETECTINVERTED 
         #define CARDINSERTED (READ(SDCARDDETECT)!=0)
-
       #else
         #define CARDINSERTED (READ(SDCARDDETECT)==0)
-    }
       #endif
-
     #endif  //SDCARDTETECTINVERTED
 
   #else