Apply AUTO_POWER_CONTROL later in setup() (#21193)

Co-authored-by: Scott Lahteine <thinkyhead@users.noreply.github.com>

Marlin/src/MarlinCore.cpp

@@ -915,12 +915,6 @@ void setup() {
     OUT_WRITE(SUICIDE_PIN, !SUICIDE_PIN_INVERTING);
   #endif
 
-  #if ENABLED(PSU_CONTROL)
-    SETUP_LOG("PSU_CONTROL");
-    powersupply_on = ENABLED(PSU_DEFAULT_OFF);
-    if (ENABLED(PSU_DEFAULT_OFF)) PSU_OFF(); else PSU_ON();
-  #endif
-
   #if EITHER(DISABLE_DEBUG, DISABLE_JTAG)
     // Disable any hardware debug to free up pins for IO
     #if ENABLED(DISABLE_DEBUG) && defined(JTAGSWD_DISABLE)
@@ -951,10 +945,6 @@ void setup() {
     OUT_WRITE(MAX6675_SS2_PIN, HIGH); // Disable
   #endif
 
-  #if HAS_L64XX
-    SETUP_RUN(L64xxManager.init());  // Set up SPI, init drivers
-  #endif
-
   #if ENABLED(DUET_SMART_EFFECTOR) && PIN_EXISTS(SMART_EFFECTOR_MOD)
     OUT_WRITE(SMART_EFFECTOR_MOD_PIN, LOW);   // Put Smart Effector into NORMAL mode
   #endif
@@ -963,10 +953,20 @@ void setup() {
     SETUP_RUN(runout.setup());
   #endif
 
+  #if ENABLED(PSU_CONTROL)
+    SETUP_LOG("PSU_CONTROL");
+    powersupply_on = ENABLED(PSU_DEFAULT_OFF);
+    if (ENABLED(PSU_DEFAULT_OFF)) PSU_OFF(); else PSU_ON();
+  #endif
+
   #if ENABLED(POWER_LOSS_RECOVERY)
     SETUP_RUN(recovery.setup());
   #endif
 
+  #if HAS_L64XX
+    SETUP_RUN(L64xxManager.init());  // Set up SPI, init drivers
+  #endif
+
   #if HAS_TMC220x
     SETUP_RUN(tmc_serial_begin());
   #endif