Browse Source

Restore ENDSTOPPULLUPS in Configuration.h

pull/1/head
Scott Lahteine 10 years ago
parent
commit
5e82ed4f30
  1. 19
      Marlin/Configuration.h

19
Marlin/Configuration.h

@ -302,13 +302,18 @@ your extruder heater takes 2 minutes to hit the target on heating.
// Enable this option for Toshiba steppers // Enable this option for Toshiba steppers
// #define CONFIG_STEPPERS_TOSHIBA // #define CONFIG_STEPPERS_TOSHIBA
// The pullups are needed if you directly connect a mechanical endstop between the signal and ground pins. // coarse Endstop Settings
#define ENDSTOPPULLUP_XMAX #define ENDSTOPPULLUPS // Comment this out (using // at the start of the line) to disable the endstop pullup resistors
#define ENDSTOPPULLUP_YMAX
#define ENDSTOPPULLUP_ZMAX #ifndef ENDSTOPPULLUPS
#define ENDSTOPPULLUP_XMIN // fine endstop settings: Individual pullups. will be ignored if ENDSTOPPULLUPS is defined
#define ENDSTOPPULLUP_YMIN // #define ENDSTOPPULLUP_XMAX
#define ENDSTOPPULLUP_ZMIN // #define ENDSTOPPULLUP_YMAX
// #define ENDSTOPPULLUP_ZMAX
// #define ENDSTOPPULLUP_XMIN
// #define ENDSTOPPULLUP_YMIN
// #define ENDSTOPPULLUP_ZMIN
#endif
// Mechanical endstop with COM to ground and NC to Signal uses "false" here (most common setup). // Mechanical endstop with COM to ground and NC to Signal uses "false" here (most common setup).
const bool X_MIN_ENDSTOP_INVERTING = false; // set to true to invert the logic of the endstop. const bool X_MIN_ENDSTOP_INVERTING = false; // set to true to invert the logic of the endstop.

Loading…
Cancel
Save