// We also need to define pin to port number mapping for the 2560 to match the pins listed above. If you change the TLC pins, update this as well per the 2560 datasheet!
// This currently only works with the RA Board.
#define TLC_CLOCK_BIT 3//bit 3 on port A
#define TLC_CLOCK_PORT &PORTA// bit 3 on port A
// We also need to define pin to port number mapping for the 2560 to match the pins listed above.
// If you change the TLC pins, update this as well per the 2560 datasheet! This currently only works with the RA Board.
#define TLC_CLOCK_BIT 3
#define TLC_CLOCK_PORT &PORTA
#define TLC_BLANK_BIT 1//bit 1 on port A
#define TLC_BLANK_PORT &PORTA// bit 1 on port A
#define TLC_BLANK_BIT 1
#define TLC_BLANK_PORT &PORTA
#define TLC_DATA_BIT 2 // bit 2 on port A
#define TLC_DATA_PORT &PORTA// bit 2 on port A
#define TLC_DATA_BIT 2
#define TLC_DATA_PORT &PORTA
#define TLC_XLAT_BIT 0 // bit 0 on port A
#define TLC_XLAT_PORT &PORTA// bit 0 on port A
#define TLC_XLAT_BIT 0
#define TLC_XLAT_PORT &PORTA
// change this to match your situation. Lots of TLCs takes up the arduino SRAM very quickly, so be careful
// Change this to match your situation. Lots of TLCs takes up the arduino SRAM very quickly, so be careful
// Leave it at at least 1 if you have enabled RA_LIGHTING
// The number of TLC5947 boards chained together for use with the animation, additional ones will repeat the animation on them, but are not individually addressable and mimic those before them. You can leave the default at 2 even if you only have 1 TLC5947 module.
#define NUM_TLCS 2
@ -144,6 +144,6 @@
// These TRANS_ARRAY values let you change the order the LEDs on the lighting modules will animate for chase functions.
// Modify them according to your specific situation.
// NOTE: the array should be 8 long for every TLC you have. These defaults assume (2) TLCs.
Scott Lahteine
7 years ago