Update Anycubic Kossel config (#15935)

config/examples/delta/Anycubic/Kossel/Configuration.h

@@ -1130,12 +1130,12 @@
  * Example: `M851 Z-5` with a CLEARANCE of 4  =>  9mm from bed to nozzle.
  *     But: `M851 Z+1` with a CLEARANCE of 2  =>  2mm from bed to nozzle.
  */
-#define Z_CLEARANCE_DEPLOY_PROBE   30 // Z Clearance for Deploy/Stow
+#define Z_CLEARANCE_DEPLOY_PROBE   50 // Z Clearance for Deploy/Stow
 #define Z_CLEARANCE_BETWEEN_PROBES 5 // Z Clearance between probe points
 #define Z_CLEARANCE_MULTI_PROBE    5 // Z Clearance between multiple probes
-#define Z_AFTER_PROBING            5 // Z position after probing is done
+//#define Z_AFTER_PROBING          5 // Z position after probing is done
 
-#define Z_PROBE_LOW_POINT          -2 // Farthest distance below the trigger-point to go before stopping
+#define Z_PROBE_LOW_POINT          -5 // Farthest distance below the trigger-point to go before stopping
 
 // For M851 give a range for adjusting the Z probe offset
 #define Z_PROBE_OFFSET_RANGE_MIN -40
@@ -1438,19 +1438,6 @@
 
 #endif // BED_LEVELING
 
-/**
- * Points to probe for all 3-point Leveling procedures.
- * Override if the automatically selected points are inadequate.
- */
-#if EITHER(AUTO_BED_LEVELING_3POINT, AUTO_BED_LEVELING_UBL)
-  #define PROBE_PT_1_X -40
-  #define PROBE_PT_1_Y 60
-  #define PROBE_PT_2_X 40
-  #define PROBE_PT_2_Y 60
-  #define PROBE_PT_3_X 0
-  #define PROBE_PT_3_Y -70
-#endif
-
 /**
  * Add a bed leveling sub-menu for ABL or MBL.
  * Include a guided procedure if manual probing is enabled.

config/examples/delta/Anycubic/Kossel/Configuration_adv.h

@@ -661,7 +661,7 @@
 #define DEFAULT_MINIMUMFEEDRATE       0.0     // minimum feedrate
 #define DEFAULT_MINTRAVELFEEDRATE     0.0
 
-//#define HOME_AFTER_DEACTIVATE  // Require rehoming after steppers are deactivated
+#define HOME_AFTER_DEACTIVATE  // Require rehoming after steppers are deactivated
 
 // Minimum time that a segment needs to take if the buffer is emptied
 #define DEFAULT_MINSEGMENTTIME        20000   // (ms)