Marlin 2.0 for Flying Bear 4S/5
You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
 
 
 
 
 
 

44 lines
1.5 KiB

/**
* Marlin 3D Printer Firmware
* Copyright (c) 2020 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]
*
* Based on Sprinter and grbl.
* Copyright (c) 2011 Camiel Gubbels / Erik van der Zalm
*
* This program is free software: you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation, either version 3 of the License, or
* (at your option) any later version.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program. If not, see <https://www.gnu.org/licenses/>.
*
*/
#pragma once
/**
* Creality v4.5.2 (STM32F103RET6) board pin assignments
*/
#if HAS_MULTI_HOTEND || E_STEPPERS > 1
#error "Creality v4.5.2 only supports one hotend / E-stepper. Comment out this line to continue."
#endif
#define BOARD_INFO_NAME "Creality v4.5.2"
#define HEATER_0_PIN PA1 // HEATER1
#define HEATER_BED_PIN PA2 // HOT BED
#define FAN_PIN PA0 // FAN
#if ENABLED(PROBE_ACTIVATION_SWITCH)
#ifndef PROBE_ACTIVATION_SWITCH_PIN
#define PROBE_ACTIVATION_SWITCH_PIN PC6 // Optoswitch to Enable Z Probe
#endif
#endif
#include "pins_CREALITY_V45x.h"