#!/usr/bin/env bash
#
# Build tests for STM32F103RE
#

# exit on first failure
set -e

#
# Build with the default configurations
#
restore_configs
opt_set MOTHERBOARD BOARD_STM32F103RE SERIAL_PORT -1 EXTRUDERS 2 \
        NOZZLE_CLEAN_START_POINT "{ {  10, 10, 3 }, {  10, 10, 3 } }" \
        NOZZLE_CLEAN_END_POINT "{ {  10, 20, 3 }, {  10, 20, 3 } }"
opt_enable EEPROM_SETTINGS EEPROM_CHITCHAT REPRAP_DISCOUNT_SMART_CONTROLLER SDSUPPORT \
           PAREN_COMMENTS GCODE_MOTION_MODES SINGLENOZZLE TOOLCHANGE_FILAMENT_SWAP TOOLCHANGE_PARK \
           BAUD_RATE_GCODE GCODE_MACROS NOZZLE_PARK_FEATURE NOZZLE_CLEAN_FEATURE
exec_test $1 $2 "STM32F1R EEPROM_SETTINGS EEPROM_CHITCHAT REPRAP_DISCOUNT_SMART_CONTROLLER SDSUPPORT PAREN_COMMENTS GCODE_MOTION_MODES" "$3"

# cleanup
restore_configs