No matter what LANGUAGE_CHOICE was set to it would always take the en branch.
I revamped it a bit to use a macro to create the language include file name. This required a slight tweak to the RU declaration since it's special-cased in a couple places in code.
This is an attempt to pull my changes from #1222 over.
Here comes a compile-time operation to match the extruder symbols on the
info screen to the set number of extruders in configuration.h.
When only one extruder is selected, the "1" on the symbol will not be
displayed.
Added support to show the filament width on the status line of the
graphic LCD. The status will show for 5 sec and then switch over to
data. Status can be seen by clicking the button.
- fixed long menu entries (>14 or >18 chars) caused overrun in dogm lcd
implementation
- fixed pin set problem when in interrupt
- much faster ST7920 SW-SPI implementation
- increased ST7920 framebuffer size for more speed
Reviert previous change of #if BLAH_PIN > 0 to #if defined(BLAH_PIN) &&
BLAH_PIN > -1. Unfortunately some times pin 0 is used. For my sins I've
gone through and replaced all unsafe checks of #if BLAH_PIN > -1 with
the safe version.
Bo Herrmannsen
wgm4321
Scott Lahteine
Caleb Anderson
Jonas
Filip Mulier
Maik Stohn
Michael Mayer
Robert F-C
MaikStohn
Dirk Eichel