The Check Endstop logic must be:
if (current_block->steps_x != current_block->steps_y || (TEST(out_bits,
X_AXIS) == TEST(out_bits, Y_AXIS)))
if (TEST(out_bits, X_HEAD))
not
if (TEST(out_bits, X_HEAD) && (current_block->steps_x !=
current_block->steps_y || (TEST(out_bits, X_AXIS) == TEST(out_bits,
Y_AXIS))))
Same applies for Y axis.
- Add BIT and TEST macros
- Add _APPLY_ macros to stepper.cpp to help with consolidation
- Consolidate code in stepper.cpp using macros
- Apply standards in stepper.cpp
- Use >= 0 instead of > -1 as a better semantic
- Replace DUAL_Y_CARRIAGE with Y_DUAL_STEPPER_DRIVERS
short:
this script scans the first few lines from a gcode. If the line between 2 different z are greater than min_g1 this is our first layer. On this layer we search the min and max values of X and Y. With an offset we write that in a new file.
Added option to set Travel Acceleration (non printing moves).
The M204 options was a non sense (S for printing moves and T for retract
moves).
It has been changed to:
P = Printing moves
R = Retract only (no X, Y, Z) moves
T = Travel (non
printing) moves
I will add this info o G-Code wiki in reprap.org. I also advise to put
this info in Marlin next version changelog.
Top -> down
- Decide what output function is to use.
- Precautions. If non of the DISPLAY_CHARSET_HD44780's is selected fall back to Japanese.
- When we are not on the dogms setup a mapping table depending on display type and mapper.
- If we are on dogm we use ONE To ONE mapping - except kanji.
- select and define one of the mapping functions.
AnHardt
alexborro
Wurstnase
maverikou
Scott Lahteine
Edward Patel
chris-bo
chrono