Initialize the display earlier

to have it ready to display errors during (temperature)-setup.

Marlin/Marlin_main.cpp

@@ -641,6 +641,9 @@ void setup() {
   // loads data from EEPROM if available else uses defaults (and resets step acceleration rate)
   Config_RetrieveSettings();
 
+  lcd_init();
+  _delay_ms(1000);  // wait 1sec to display the splash screen
+
   tp_init();    // Initialize temperature loop
   plan_init();  // Initialize planner;
   watchdog_init();
@@ -648,9 +651,6 @@ void setup() {
   setup_photpin();
   servo_init();
 
-  lcd_init();
-  _delay_ms(1000);  // wait 1sec to display the splash screen
-
   #if HAS_CONTROLLERFAN
     SET_OUTPUT(CONTROLLERFAN_PIN); //Set pin used for driver cooling fan
   #endif