From e7707aedbc5ec9c5ccb1962a8ba22fa89ebf8095 Mon Sep 17 00:00:00 2001 From: Charles Bell Date: Mon, 4 Aug 2014 10:18:25 -0400 Subject: [PATCH] Commented out new #defines in Configuration.h. --- Marlin/Configuration.h | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/Marlin/Configuration.h b/Marlin/Configuration.h index 61199a0af6..d2b7ecfe8d 100644 --- a/Marlin/Configuration.h +++ b/Marlin/Configuration.h @@ -436,8 +436,8 @@ const bool Z_MAX_ENDSTOP_INVERTING = true; // set to true to invert the logic of #define Z_RAISE_BEFORE_PROBING 15 //How much the extruder will be raised before traveling to the first probing point. #define Z_RAISE_BETWEEN_PROBINGS 5 //How much the extruder will be raised when traveling from between next probing points - #define Z_PROBE_SLED // turn on if you have a z-probe mounted on a sled like those designed by Charles Bell - #define SLED_DOCKING_OFFSET 5 // the extra distance the X axis must travel to pickup the sled. 0 should be fine but you can push it further if you'd like. + //#define Z_PROBE_SLED // turn on if you have a z-probe mounted on a sled like those designed by Charles Bell + //#define SLED_DOCKING_OFFSET 5 // the extra distance the X axis must travel to pickup the sled. 0 should be fine but you can push it further if you'd like. //If defined, the Probe servo will be turned on only during movement and then turned off to avoid jerk //The value is the delay to turn the servo off after powered on - depends on the servo speed; 300ms is good value, but you can try lower it.