From d6c5c503d4d72a6d08314967f2996e83d1b05f4d Mon Sep 17 00:00:00 2001 From: whosawhatsis Date: Wed, 12 Feb 2014 12:59:50 -0800 Subject: [PATCH] correct feedrate units in comments for M207/M208 --- Marlin/Marlin_main.cpp | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/Marlin/Marlin_main.cpp b/Marlin/Marlin_main.cpp index 5f8f86f784..ab14f9907f 100644 --- a/Marlin/Marlin_main.cpp +++ b/Marlin/Marlin_main.cpp @@ -137,8 +137,8 @@ // M204 - Set default acceleration: S normal moves T filament only moves (M204 S3000 T7000) im mm/sec^2 also sets minimum segment time in ms (B20000) to prevent buffer underruns and M20 minimum feedrate // M205 - advanced settings: minimum travel speed S=while printing T=travel only, B=minimum segment time X= maximum xy jerk, Z=maximum Z jerk, E=maximum E jerk // M206 - set additional homeing offset -// M207 - set retract length S[positive mm] F[feedrate mm/sec] Z[additional zlift/hop], stays in mm regardless of M200 setting -// M208 - set recover=unretract length S[positive mm surplus to the M207 S*] F[feedrate mm/sec] +// M207 - set retract length S[positive mm] F[feedrate mm/min] Z[additional zlift/hop], stays in mm regardless of M200 setting +// M208 - set recover=unretract length S[positive mm surplus to the M207 S*] F[feedrate mm/min] // M209 - S<1=true/0=false> enable automatic retract detect if the slicer did not support G10/11: every normal extrude-only move will be classified as retract depending on the direction. // M218 - set hotend offset (in mm): T X Y // M220 S- set speed factor override percentage