diff --git a/Marlin/src/gcode/bedlevel/G35.cpp b/Marlin/src/gcode/bedlevel/G35.cpp
index f6ae2db2c7..b39a7b9ed8 100755
--- a/Marlin/src/gcode/bedlevel/G35.cpp
+++ b/Marlin/src/gcode/bedlevel/G35.cpp
@@ -129,15 +129,19 @@ void GcodeSuite::G35() {
     const float z_probed_height = probe.probe_at_point(screws_tilt_adjust_pos[i], PROBE_PT_RAISE, 0, true);
 
     if (isnan(z_probed_height)) {
-      SERIAL_ECHOPAIR("G35 failed at point ", int(i), " (", tramming_point_name[i], ")");
+      SERIAL_ECHOPAIR("G35 failed at point ", int(i), " (");
+      SERIAL_ECHOPGM_P((char *)pgm_read_ptr(&tramming_point_name[i]));
+      SERIAL_CHAR(')');
       SERIAL_ECHOLNPAIR_P(SP_X_STR, screws_tilt_adjust_pos[i].x, SP_Y_STR, screws_tilt_adjust_pos[i].y);
       err_break = true;
       break;
     }
 
     if (DEBUGGING(LEVELING)) {
-      DEBUG_ECHOPAIR("Probing point ", int(i), " (", tramming_point_name[i], ")");
-      SERIAL_ECHOLNPAIR_P(SP_X_STR, screws_tilt_adjust_pos[i].x, SP_Y_STR, screws_tilt_adjust_pos[i].y, SP_Z_STR, z_probed_height);
+      DEBUG_ECHOPAIR("Probing point ", int(i), " (");
+      DEBUG_PRINT_P((char *)pgm_read_ptr(&tramming_point_name[i]));
+      DEBUG_CHAR(')');
+      DEBUG_ECHOLNPAIR_P(SP_X_STR, screws_tilt_adjust_pos[i].x, SP_Y_STR, screws_tilt_adjust_pos[i].y, SP_Z_STR, z_probed_height);
     }
 
     z_measured[i] = z_probed_height;
@@ -155,9 +159,9 @@ void GcodeSuite::G35() {
       const float decimal_part = adjust - float(full_turns);
       const int minutes = trunc(decimal_part * 60.0f);
 
-      SERIAL_ECHOPAIR("Turn ", tramming_point_name[i],
-             " ", (screw_thread & 1) == (adjust > 0) ? "CCW" : "CW",
-             " by ", abs(full_turns), " turns");
+      SERIAL_ECHOPGM("Turn ");
+      SERIAL_ECHOPGM_P((char *)pgm_read_ptr(&tramming_point_name[i]));
+      SERIAL_ECHOPAIR(" ", (screw_thread & 1) == (adjust > 0) ? "CCW" : "CW", " by ", abs(full_turns), " turns");
       if (minutes) SERIAL_ECHOPAIR(" and ", abs(minutes), " minutes");
       if (ENABLED(REPORT_TRAMMING_MM)) SERIAL_ECHOPAIR(" (", -diff, "mm)");
       SERIAL_EOL();