From b7a8dcc35d23d555ff2a6ebd64c71068d30859f2 Mon Sep 17 00:00:00 2001 From: InsanityAutomation <38436470+InsanityAutomation@users.noreply.github.com> Date: Thu, 20 Dec 2018 18:32:39 -0500 Subject: [PATCH] Update Formbot T-Rex 3 pins (#12662) --- Marlin/src/pins/pins_FORMBOT_TREX3.h | 25 +++++++------------------ 1 file changed, 7 insertions(+), 18 deletions(-) diff --git a/Marlin/src/pins/pins_FORMBOT_TREX3.h b/Marlin/src/pins/pins_FORMBOT_TREX3.h index 622c2d50c2..dde947e3a6 100644 --- a/Marlin/src/pins/pins_FORMBOT_TREX3.h +++ b/Marlin/src/pins/pins_FORMBOT_TREX3.h @@ -109,7 +109,7 @@ // #define TEMP_0_PIN 13 // Analog Input #define TEMP_1_PIN 15 // Analog Input -#define TEMP_BED_PIN 3 // Analog Input +#define TEMP_BED_PIN 14 // Analog Input // SPI for Max6675 or Max31855 Thermocouple #if DISABLED(SDSUPPORT) @@ -118,22 +118,7 @@ #define MAX6675_SS_PIN 66 // Do not use pin 49 as this is tied to the switch inside the SD card socket to detect if there is an SD card present #endif -// -// Augmentation for auto-assigning RAMPS plugs -// -#if DISABLED(IS_RAMPS_EEB) && DISABLED(IS_RAMPS_EEF) && DISABLED(IS_RAMPS_EFB) && DISABLED(IS_RAMPS_EFF) && DISABLED(IS_RAMPS_SF) && !PIN_EXISTS(MOSFET_D) - #if HOTENDS > 1 - #if TEMP_SENSOR_BED - #define IS_RAMPS_EEB - #else - #define IS_RAMPS_EEF - #endif - #elif TEMP_SENSOR_BED - #define IS_RAMPS_EFB - #else - #define IS_RAMPS_EFF - #endif -#endif + // // Heaters / Fans @@ -143,8 +128,9 @@ #define HEATER_BED_PIN 8 #define FAN_PIN 9 -//#define FAN1_PIN 4 +#define FAN1_PIN 12 +#define NUM_RUNOUT_SENSORS 2 #define FIL_RUNOUT_PIN 23 #define FIL_RUNOUT2_PIN 21 @@ -157,6 +143,9 @@ #define LED_PIN 13 #endif +#define SPINDLE_LASER_PWM_PIN 7 // MUST BE HARDWARE PWM +#define SPINDLE_LASER_ENABLE_PIN 4 // Pin should have a pullup! + // Use the RAMPS 1.4 Analog input 5 on the AUX2 connector #define FILWIDTH_PIN 5 // Analog Input