🔧 Fewer alerts about Z_SAFE_HOMING

Marlin/src/inc/SanityCheck.h

@@ -1660,10 +1660,6 @@ static_assert(Y_MAX_LENGTH >= Y_BED_SIZE, "Movement bounds (Y_MIN_POS, Y_MAX_POS
     #error "Z_PROBE_LOW_POINT must be less than or equal to 0."
   #endif
 
-  #if HOMING_Z_WITH_PROBE && IS_CARTESIAN && DISABLED(Z_SAFE_HOMING)
-    #error "Z_SAFE_HOMING is recommended when homing with a probe. Enable it or comment out this line to continue."
-  #endif
-
   #if ENABLED(PROBE_ACTIVATION_SWITCH)
     #ifndef PROBE_ACTIVATION_SWITCH_STATE
       #error "PROBE_ACTIVATION_SWITCH_STATE is required for PROBE_ACTIVATION_SWITCH."

Marlin/src/inc/Warnings.cpp

@@ -484,3 +484,7 @@
 #if ENABLED(EMIT_CREALITY_422_WARNING) || MB(CREALITY_V4)
   #warning "Creality 4.2.2 boards may have A4988 or TMC2208_STANDALONE drivers. Check your board and make sure to select the correct DRIVER_TYPE!"
 #endif
+
+#if HOMING_Z_WITH_PROBE && IS_CARTESIAN && DISABLED(Z_SAFE_HOMING)
+  #error "Z_SAFE_HOMING is recommended when homing with a probe. Enable Z_SAFE_HOMING or comment out this line to continue."
+#endif