Browse Source

Follow-up the PR #4271 (X_DUAL_STEPPER_DRIVERS)

・Update a forgotten Configuration_adv.h of K8400
pull/1/head
esenapaj 8 years ago
parent
commit
9b5cbf2423
  1. 33
      Marlin/example_configurations/K8400/Configuration_adv.h

33
Marlin/example_configurations/K8400/Configuration_adv.h

@ -229,11 +229,28 @@
//#define Z_LATE_ENABLE // Enable Z the last moment. Needed if your Z driver overheats. //#define Z_LATE_ENABLE // Enable Z the last moment. Needed if your Z driver overheats.
// Dual X Steppers
// Uncomment this option to drive two X axis motors.
// The next unused E driver will be assigned to the second X stepper.
//#define X_DUAL_STEPPER_DRIVERS
#if ENABLED(X_DUAL_STEPPER_DRIVERS)
// Set true if the two X motors need to rotate in opposite directions
#define INVERT_X2_VS_X_DIR true
#endif
// Dual Y Steppers
// Uncomment this option to drive two Y axis motors.
// The next unused E driver will be assigned to the second Y stepper.
//#define Y_DUAL_STEPPER_DRIVERS
#if ENABLED(Y_DUAL_STEPPER_DRIVERS)
// Set true if the two Y motors need to rotate in opposite directions
#define INVERT_Y2_VS_Y_DIR true
#endif
// A single Z stepper driver is usually used to drive 2 stepper motors. // A single Z stepper driver is usually used to drive 2 stepper motors.
// Uncomment this define to utilize a separate stepper driver for each Z axis motor. // Uncomment this option to use a separate stepper driver for each Z axis motor.
// Only a few motherboards support this, like RAMPS, which have dual extruder support (the 2nd, often unused, extruder driver is used // The next unused E driver will be assigned to the second Z stepper.
// to control the 2nd Z axis stepper motor). The pins are currently only defined for a RAMPS motherboards.
// On a RAMPS (or other 5 driver) motherboard, using this feature will limit you to using 1 extruder.
//#define Z_DUAL_STEPPER_DRIVERS //#define Z_DUAL_STEPPER_DRIVERS
#if ENABLED(Z_DUAL_STEPPER_DRIVERS) #if ENABLED(Z_DUAL_STEPPER_DRIVERS)
@ -255,14 +272,6 @@
#endif // Z_DUAL_STEPPER_DRIVERS #endif // Z_DUAL_STEPPER_DRIVERS
// Same again but for Y Axis.
//#define Y_DUAL_STEPPER_DRIVERS
#if ENABLED(Y_DUAL_STEPPER_DRIVERS)
// Define if the two Y drives need to rotate in opposite directions
#define INVERT_Y2_VS_Y_DIR true
#endif
// Enable this for dual x-carriage printers. // Enable this for dual x-carriage printers.
// A dual x-carriage design has the advantage that the inactive extruder can be parked which // A dual x-carriage design has the advantage that the inactive extruder can be parked which
// prevents hot-end ooze contaminating the print. It also reduces the weight of each x-carriage // prevents hot-end ooze contaminating the print. It also reduces the weight of each x-carriage

Loading…
Cancel
Save