From 81c0a918af8b6e21cb969ecb31f854f4712e7ca1 Mon Sep 17 00:00:00 2001
From: Scott Lahteine <github@thinkyhead.com>
Date: Wed, 6 Dec 2017 23:03:33 -0600
Subject: [PATCH] feed_factor => inverse_secs

---
 Marlin/src/module/motion.cpp | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/Marlin/src/module/motion.cpp b/Marlin/src/module/motion.cpp
index 8ed841be3a..b013faf353 100644
--- a/Marlin/src/module/motion.cpp
+++ b/Marlin/src/module/motion.cpp
@@ -578,7 +578,7 @@ float soft_endstop_min[XYZ] = { X_MIN_BED, Y_MIN_BED, Z_MIN_POS },
     #if IS_SCARA && ENABLED(SCARA_FEEDRATE_SCALING)
       // SCARA needs to scale the feed rate from mm/s to degrees/s
       const float inv_segment_length = min(10.0, float(segments) / cartesian_mm), // 1/mm/segs
-                  feed_factor = inv_segment_length * _feedrate_mm_s;
+                  inverse_secs = inv_segment_length * _feedrate_mm_s;
       float oldA = stepper.get_axis_position_degrees(A_AXIS),
             oldB = stepper.get_axis_position_degrees(B_AXIS);
     #endif
@@ -612,7 +612,7 @@ float soft_endstop_min[XYZ] = { X_MIN_BED, Y_MIN_BED, Z_MIN_POS },
         // Use ratio between the length of the move and the larger angle change
         const float adiff = abs(delta[A_AXIS] - oldA),
                     bdiff = abs(delta[B_AXIS] - oldB);
-        planner.buffer_line(delta[A_AXIS], delta[B_AXIS], delta[C_AXIS], raw[E_AXIS], max(adiff, bdiff) * feed_factor, active_extruder);
+        planner.buffer_line(delta[A_AXIS], delta[B_AXIS], delta[C_AXIS], raw[E_AXIS], max(adiff, bdiff) * inverse_secs, active_extruder);
         oldA = delta[A_AXIS];
         oldB = delta[B_AXIS];
       #else
@@ -630,7 +630,7 @@ float soft_endstop_min[XYZ] = { X_MIN_BED, Y_MIN_BED, Z_MIN_POS },
       ADJUST_DELTA(rtarget);
       const float adiff = abs(delta[A_AXIS] - oldA),
                   bdiff = abs(delta[B_AXIS] - oldB);
-      planner.buffer_line(delta[A_AXIS], delta[B_AXIS], delta[C_AXIS], raw[E_AXIS], max(adiff, bdiff) * feed_factor, active_extruder);
+      planner.buffer_line(delta[A_AXIS], delta[B_AXIS], delta[C_AXIS], raw[E_AXIS], max(adiff, bdiff) * inverse_secs, active_extruder);
     #else
       planner.buffer_line_kinematic(rtarget, _feedrate_mm_s, active_extruder);
     #endif