Config adjustments

Marlin/Configuration.h

@@ -2359,7 +2359,7 @@
   #define NEOPIXEL_PIN     4       // LED driving pin
   //#define NEOPIXEL2_TYPE NEOPIXEL_TYPE
   //#define NEOPIXEL2_PIN    5
-  #define NEOPIXEL2_INSERIES false // The default behaviour is 'false' with neopixel2 in parallel
+  //#define NEOPIXEL2_INSERIES     // Default behavior is NeoPixel 2 in parallel
   #define NEOPIXEL_PIXELS 30       // Number of LEDs in the strip, larger of 2 strips if 2 neopixel strips are used
   #define NEOPIXEL_IS_SEQUENTIAL   // Sequential display for temperature change - LED by LED. Disable to change all LEDs at once.
   #define NEOPIXEL_BRIGHTNESS 127  // Initial brightness (0-255)

Marlin/Configuration_adv.h

@@ -825,13 +825,13 @@
 
 //#define HOME_AFTER_DEACTIVATE  // Require rehoming after steppers are deactivated
 
-// Minimum time that a segment needs to take as the buffer gets emptied
-#define DEFAULT_MINSEGMENTTIME        20000   // (µs) Set with M205 B.
-
 // Default Minimum Feedrates for printing and travel moves
 #define DEFAULT_MINIMUMFEEDRATE       0.0     // (mm/s) Minimum feedrate. Set with M205 S.
 #define DEFAULT_MINTRAVELFEEDRATE     0.0     // (mm/s) Minimum travel feedrate. Set with M205 T.
 
+// Minimum time that a segment needs to take as the buffer gets emptied
+#define DEFAULT_MINSEGMENTTIME        20000   // (µs) Set with M205 B.
+
 // Slow down the machine if the lookahead buffer is (by default) half full.
 // Increase the slowdown divisor for larger buffer sizes.
 #define SLOWDOWN