PID range/Home Offset Menu

Marlin/Configuration.h

@@ -559,7 +559,7 @@
   //#define PID_DEBUG             // Sends debug data to the serial port. Use 'M303 D' to toggle activation.
   //#define PID_OPENLOOP          // Puts PID in open loop. M104/M140 sets the output power from 0 to PID_MAX
   //#define SLOW_PWM_HEATERS      // PWM with very low frequency (roughly 0.125Hz=8s) and minimum state time of approximately 1s useful for heaters driven by a relay
-  #define PID_FUNCTIONAL_RANGE 10 // If the temperature difference between the target temperature and the actual temperature
+  #define PID_FUNCTIONAL_RANGE 20 // If the temperature difference between the target temperature and the actual temperature
                                   // is more than PID_FUNCTIONAL_RANGE then the PID will be shut off and the heater will be set to min/max.
 #endif
 

Marlin/Configuration_adv.h

@@ -3158,7 +3158,7 @@
  *  - M206 and M428 are disabled.
  *  - G92 will revert to its behavior from Marlin 1.0.
  */
-//#define NO_WORKSPACE_OFFSETS
+#define NO_WORKSPACE_OFFSETS
 
 // Extra options for the M114 "Current Position" report
 //#define M114_DETAIL         // Use 'M114` for details to check planner calculations