From 4aa2490099153c44a2901c978b6b51bb1d3a67fd Mon Sep 17 00:00:00 2001 From: Bo Herrmannsen Date: Sat, 9 May 2015 23:14:52 +0200 Subject: [PATCH] moved to http://www.marlinfirmware.org/ --- Documentation/RampsServoPower.md | 9 --------- 1 file changed, 9 deletions(-) delete mode 100644 Documentation/RampsServoPower.md diff --git a/Documentation/RampsServoPower.md b/Documentation/RampsServoPower.md deleted file mode 100644 index 2f715cfd73..0000000000 --- a/Documentation/RampsServoPower.md +++ /dev/null @@ -1,9 +0,0 @@ - - -__Note for RAMPS users:__ ----------------------- - --By default, RAMPS have no power on servo bus (if you happen to have a multimeter, check the voltage on servo power pins). --In order to get the servo working, you need to supply 5V to 5V pin.. You can do it using your power supply (if it has a 5V output) or jumping the "Vcc" from Arduino to the 5V RAMPS rail. --These 2 pins are located just between the Reset Button and the yellow fuses... There are marks in the board showing 5V and VCC.. just connect them.. --If jumping the arduino Vcc do RAMPS 5V rail, take care to not use a power hungry servo, otherwise you will cause a blackout in the arduino board ;-)