Upstream Merge Fixes

Marlin/example_configurations/Felix/Configuration.h

@@ -263,15 +263,15 @@ your extruder heater takes 2 minutes to hit the target on heating.
 // uncomment the 2 defines below:
 
 // Parameters for all extruder heaters
-#define THERMAL_RUNAWAY_PROTECTION_PERIOD 60 //in seconds
+//#define THERMAL_RUNAWAY_PROTECTION_PERIOD 60 //in seconds
-#define THERMAL_RUNAWAY_PROTECTION_HYSTERESIS 5 // in degree Celsius
+//#define THERMAL_RUNAWAY_PROTECTION_HYSTERESIS 5 // in degree Celsius
 
 // If you want to enable this feature for your bed heater,
 // uncomment the 2 defines below:
 
 // Parameters for the bed heater
-#define THERMAL_RUNAWAY_PROTECTION_BED_PERIOD 30 //in seconds
+//#define THERMAL_RUNAWAY_PROTECTION_BED_PERIOD 30 //in seconds
-#define THERMAL_RUNAWAY_PROTECTION_BED_HYSTERESIS 5// in degree Celsius
+//#define THERMAL_RUNAWAY_PROTECTION_BED_HYSTERESIS 5// in degree Celsius
 
 
 //===========================================================================

Marlin/example_configurations/Felix/Configuration_DUAL.h

@@ -263,15 +263,15 @@ your extruder heater takes 2 minutes to hit the target on heating.
 // uncomment the 2 defines below:
 
 // Parameters for all extruder heaters
-#define THERMAL_RUNAWAY_PROTECTION_PERIOD 60 //in seconds
+//#define THERMAL_RUNAWAY_PROTECTION_PERIOD 60 //in seconds
-#define THERMAL_RUNAWAY_PROTECTION_HYSTERESIS 5 // in degree Celsius
+//#define THERMAL_RUNAWAY_PROTECTION_HYSTERESIS 5 // in degree Celsius
 
 // If you want to enable this feature for your bed heater,
 // uncomment the 2 defines below:
 
 // Parameters for the bed heater
-#define THERMAL_RUNAWAY_PROTECTION_BED_PERIOD 30 //in seconds
+//#define THERMAL_RUNAWAY_PROTECTION_BED_PERIOD 30 //in seconds
-#define THERMAL_RUNAWAY_PROTECTION_BED_HYSTERESIS 5// in degree Celsius
+//#define THERMAL_RUNAWAY_PROTECTION_BED_HYSTERESIS 5// in degree Celsius
 
 
 //===========================================================================

Marlin/example_configurations/Felix/Configuration_adv.h

@@ -213,7 +213,8 @@
 //homing hits the endstop, then retracts by this distance, before it tries to slowly bump again:
 #define X_HOME_RETRACT_MM 5
 #define Y_HOME_RETRACT_MM 5
-#define Z_HOME_RETRACT_MM 2
+#define Z_HOME_RETRACT_MM 3
+#define HOMING_BUMP_DIVISOR {10, 10, 20}  // Re-Bump Speed Divisor (Divides the Homing Feedrate)
 //#define QUICK_HOME  //if this is defined, if both x and y are to be homed, a diagonal move will be performed initially.
 
 #define AXIS_RELATIVE_MODES {false, false, false, false}