Browse Source
Group related homing options (#20283)
Co-authored-by: Scott Lahteine <thinkyhead@users.noreply.github.com>
vanilla_fb_2.0.x
Sergey1560
4 years ago
committed by
GitHub
No known key found for this signature in database
GPG Key ID: 4AEE18F83AFDEB23
2 changed files with
2 additions and
4 deletions
-
Marlin/Configuration.h
-
Marlin/Configuration_adv.h
|
|
@ -1099,8 +1099,8 @@ |
|
|
|
|
|
|
|
|
// @section homing
|
|
|
// @section homing
|
|
|
|
|
|
|
|
|
//#define NO_MOTION_BEFORE_HOMING // Inhibit movement until all axes have been homed
|
|
|
//#define NO_MOTION_BEFORE_HOMING // Inhibit movement until all axes have been homed. Also enable HOME_AFTER_DEACTIVATE for extra safety.
|
|
|
|
|
|
//#define HOME_AFTER_DEACTIVATE // Require rehoming after steppers are deactivated. Also enable NO_MOTION_BEFORE_HOMING for extra safety.
|
|
|
//#define UNKNOWN_Z_NO_RAISE // Don't raise Z (lower the bed) if Z is "unknown." For beds that fall when Z is powered off.
|
|
|
//#define UNKNOWN_Z_NO_RAISE // Don't raise Z (lower the bed) if Z is "unknown." For beds that fall when Z is powered off.
|
|
|
|
|
|
|
|
|
//#define Z_HOMING_HEIGHT 4 // (mm) Minimal Z height before homing (G28) for Z clearance above the bed, clamps, ...
|
|
|
//#define Z_HOMING_HEIGHT 4 // (mm) Minimal Z height before homing (G28) for Z clearance above the bed, clamps, ...
|
|
|
|
|
|
@ -854,8 +854,6 @@ |
|
|
// If the Nozzle or Bed falls when the Z stepper is disabled, set its resting position here.
|
|
|
// If the Nozzle or Bed falls when the Z stepper is disabled, set its resting position here.
|
|
|
//#define Z_AFTER_DEACTIVATE Z_HOME_POS
|
|
|
//#define Z_AFTER_DEACTIVATE Z_HOME_POS
|
|
|
|
|
|
|
|
|
//#define HOME_AFTER_DEACTIVATE // Require rehoming after steppers are deactivated
|
|
|
|
|
|
|
|
|
|
|
|
// Default Minimum Feedrates for printing and travel moves
|
|
|
// Default Minimum Feedrates for printing and travel moves
|
|
|
#define DEFAULT_MINIMUMFEEDRATE 0.0 // (mm/s) Minimum feedrate. Set with M205 S.
|
|
|
#define DEFAULT_MINIMUMFEEDRATE 0.0 // (mm/s) Minimum feedrate. Set with M205 S.
|
|
|
#define DEFAULT_MINTRAVELFEEDRATE 0.0 // (mm/s) Minimum travel feedrate. Set with M205 T.
|
|
|
#define DEFAULT_MINTRAVELFEEDRATE 0.0 // (mm/s) Minimum travel feedrate. Set with M205 T.
|
|
|
|
