Marlin 2.0 for Flying Bear 4S/5
You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.

72 lines
2.2 KiB

/**
* Marlin 3D Printer Firmware
5 years ago
* Copyright (c) 2020 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]
*
* Based on Sprinter and grbl.
* Copyright (c) 2011 Camiel Gubbels / Erik van der Zalm
*
* This program is free software: you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation, either version 3 of the License, or
* (at your option) any later version.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program. If not, see <http://www.gnu.org/licenses/>.
*
*/
#ifdef ARDUINO_ARCH_ESP32
#include "../../inc/MarlinConfig.h"
#if HAS_SERVOS
#include "Servo.h"
// Adjacent channels (0/1, 2/3 etc.) share the same timer and therefore the same frequency and resolution settings on ESP32,
// so we only allocate servo channels up high to avoid side effects with regards to analogWrite (fans, leds, laser pwm etc.)
int Servo::channel_next_free = 12;
Servo::Servo() {
channel = channel_next_free++;
}
int8_t Servo::attach(const int inPin) {
if (channel >= CHANNEL_MAX_NUM) return -1;
if (inPin > 0) pin = inPin;
ledcSetup(channel, 50, 16); // channel X, 50 Hz, 16-bit depth
ledcAttachPin(pin, channel);
return true;
}
void Servo::detach() { ledcDetachPin(pin); }
int Servo::read() { return degrees; }
void Servo::write(int inDegrees) {
degrees = constrain(inDegrees, MIN_ANGLE, MAX_ANGLE);
int us = map(degrees, MIN_ANGLE, MAX_ANGLE, MIN_PULSE_WIDTH, MAX_PULSE_WIDTH);
int duty = map(us, 0, TAU_USEC, 0, MAX_COMPARE);
ledcWrite(channel, duty);
}
void Servo::move(const int value) {
constexpr uint16_t servo_delay[] = SERVO_DELAY;
static_assert(COUNT(servo_delay) == NUM_SERVOS, "SERVO_DELAY must be an array NUM_SERVOS long.");
if (attach(0) >= 0) {
write(value);
safe_delay(servo_delay[channel]);
#if ENABLED(DEACTIVATE_SERVOS_AFTER_MOVE)
detach();
#endif
}
}
#endif // HAS_SERVOS
#endif // ARDUINO_ARCH_ESP32